Servo Booster Spannung:7.2V for example with heat shrink

for example with heat shrink tubing

Solder the male connector to the LED and secure the wires to the body with tape

Attach the two taillights to the body using 4 of the included washers and nuts

Bringen Sie die Front-LED Halterung am vorderen Differentialgehäuse mit den mitgelieferten M2

Insert the included cable into the receiver

Servo Booster Spannung:7.2V for example with heat shrinkThe servo booster was specifically developed for vehicles where the controller receiver only outputs 6V, but the servo is designed for a higher voltage. This is often the case with Traxxas models, for example. It enables faster response speed of servo motors, resulting in noticeably better control and agility of the vehicle. It is simply installed between the receiver and the servo, and converts the existing BEC voltage to 7. 2V or 8. 4V. This is an